Saleae Logic16

Saleae Logic16, front

The Saleae Logic16 is a USB-based, 16-channel logic analyzer with 100/50/25/12.5MHz sampling rate (at 2/4/8/16 enabled channels).

The case requires a Torx T5 screwdriver to open.

See Saleae Logic16/Info for more details (such as lsusb -vvv output) about the device.

See Saleae Logic for the predecessor product of the Saleae Logic16.

Hardware

• Xilinx XC3S200A 200K gate FPGA
• Cypress CY7C68013A-56PVXC (FX2LP) USB interface chip

Photos

• 

  Device, front

• 

  Device, bottom

• 

  PCB, top

• 

  PCB, bottom

Protocol

Sample format:

The samples (as received via USB) for the enabled probes (3, 6, 9, or 16) are organized as follows:

0xLL 0xLL  0xMM 0xMM  0xNN 0xNN   0xPP 0xPP  0xQQ 0xQQ  0xRR 0xRR ...

In the above example, 3 probes are enabled. For each probe there are 2 bytes / 16 bits (e.g. 0xLL 0xLL for probe 0), then the next probe's data is received (0xMM 0xMM for probe 1), then 0xNN 0xNN for probe 2. When 2 bytes have been received for all enabled probes, the process restarts with probe 0 again.

The 16 bits of data per probe seem to contain the pin state of the respective probe (1: high, 0: low) at 16 different sampling points/times (which ones depends on the samplerate).

Resources

• Manual
• Vendor software
• SDKs