Difference between revisions of "Robomotic BugLogic 3"
Jump to navigation
Jump to search
Uwe Hermann (talk | contribs) m |
Uwe Hermann (talk | contribs) m |
||
| (One intermediate revision by the same user not shown) | |||
| Line 8: | Line 8: | ||
| samplerate_state = — | | samplerate_state = — | ||
| triggers = none (SW-only) | | triggers = none (SW-only) | ||
| voltages = | | voltages = -0.5V — 5.25V | ||
| threshold = Fixed: VIH=2.0V—5.25V, VIL=-0.5V—0.8V | |||
| memory = none | | memory = none | ||
| compression = none | | compression = none | ||
| Line 24: | Line 25: | ||
== Hardware == | == Hardware == | ||
* TODO | * '''Main chip:''' Cypress CY7C68013A-56LFXC (FX2LP) | ||
* '''I2C EEPROM''': ? | |||
* '''Octal tristate bus transceiver''': LVC245 (TODO: vendor?) | |||
* '''Crystal''': 24MHz | |||
== Photos == | == Photos == | ||
| Line 38: | Line 42: | ||
== Resources == | == Resources == | ||
* [http://www.norduino.org/index.php?title=BugLogic3_board Buglogic3 wiki page] | |||
* [http://norduino.robomotic.com/products-page/categories/buglogic3/ robomotic.com: Hardware description] | |||
[[Category:Device]] | [[Category:Device]] | ||
[[Category:Logic analyzer]] | [[Category:Logic analyzer]] | ||
[[Category:Supported]] | [[Category:Supported]] | ||
Revision as of 13:23, 28 July 2013
 | |
| Status | supported |
|---|---|
| Source code | fx2lafw |
| Channels | 8 |
| Samplerate | 24MHz |
| Samplerate (state) | — |
| Triggers | none (SW-only) |
| Min/max voltage | -0.5V — 5.25V |
| Threshold voltage | Fixed: VIH=2.0V—5.25V, VIL=-0.5V—0.8V |
| Memory | none |
| Compression | none |
| Website | robomotic.com |
The Robomotic BugLogic 3 is a USB-based, 8-channel logic analyzer with up to 24MHz sampling rate.
It is a clone of the Saleae Logic.
In sigrok, we use the open-source fx2lafw firmware for this logic analyzer.
See Robomotic BugLogic 3/Info for more details (such as lsusb -vvv output) about the device.
Hardware
- Main chip: Cypress CY7C68013A-56LFXC (FX2LP)
- I2C EEPROM: ?
- Octal tristate bus transceiver: LVC245 (TODO: vendor?)
- Crystal: 24MHz
Photos
Device, front
Protocol
Since we use the open-source fx2lafw firmware for this device, we don't need to know the protocol.