Rigol DS2000 series

From sigrok
Revision as of 01:51, 7 May 2014 by Uwe Hermann (talk | contribs) (Uwe Hermann moved page Rigol DS2000 Series to Rigol DS2000 series without leaving a redirect)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
Rigol DS2000 Series
Rigol-ds2072 mugshot.png
Status supported
Source code rigol-ds
Channels 2
Samplerate 2GSa/s (1ch), 1GSa/s (2ch)
Analog bandwidth 70-200MHz (depending on model)
Vertical resolution 8bits
Triggers edge, pulse, runt, windows, nth edge, slope, video, pattern, delay, timeout, duration, setup/hold, RS232/UART, I²C, SPI, CAN, USB
Input impedance 1MΩ‖16pF 300V RMS CAT I
Memory 56Mpts (mode/ch-dependent)
Display 8" 800x480, 160K colors
Connectivity USB host/device, ethernet (LXI), trigger out, pass/fail out
Features math: +, —, x, /, FFT, vertical sensitivity: 500µV/div - 10V/div
Website rigolna.com

The Rigol DS2000 Series are 2-channel oscilloscopes with an analog bandwidth of 70-200MHz and 2GS/s sampling rate.

Except for small software differences all models in the series are identical.

There exist two versions of the hardware, version 1 and version 2. Version 2 has a redesigned PCB which is prepared for additional modules, a signal generator and apparently a logic analyzer. Additionally version 2 hardware has the hardware fitted to switch the input impedance to 50 ohms. This is only accessible through SCPI commands, the option in the menu is disabled (as of firmware version 01.01.00.02).

Devices

Model Bandwidth
DS2072 70MHz
DS2102 100MHz
DS2202 200MHz

Protocol

The device uses USBTMC or LXI via its ethernet port for communication with a host PC. The protocol is based on SCPI commands.

Resources