Difference between revisions of "IEEE-488"
Jump to navigation
Jump to search
| Line 64: | Line 64: | ||
|} | |} | ||
== Devices == | |||
{| width="100%" border="0" style="vertical-align: top" | |||
|- bgcolor="#6699ff" | |||
! width="30%" | Device | |||
! width="20%" | Status | |||
! width="20%" | Interface | |||
! Comments | |||
|- bgcolor="#dddddd" | |||
| [[Agilent 7xxx]] | |||
| bgcolor="orange" align="center" | planned | |||
| USB-TMC | |||
| style="vertical-align: top" | The standard is available [http://www.usb.org/developers/devclass_docs/USBTMC_1_006a.zip here] | |||
|} | |||
Revision as of 20:04, 21 May 2012
IEEE-488, also known as GPIB or HP-IB, comprises a set of standards which allows various test and measurement gear to be controlled and queried remotely.
The following standards are involved:
- IEEE-488.1 mechanical, electrical and basic protocol
- IEEE-488.2 formats and common commands
- SCPI standard commands, built on top of IEEE-488.2
While IEEE-488.1 defines the "Centronix-style" parallel connector, the other standards are in fact seen over other types of connections: RS-232, DB25 parallel connectors, and so on.
Sigrok aims to support all of this: all of the command sets, on any device supporting them, across any interface.
Interfaces
| Device | Status | Comments |
|---|---|---|
| Chinese 82357B clone | planned | |
| Prologix GPIB-USB | not yet supported | Hardware needed |
| Prologix GPIB-Ethernet | not yet supported | Hardware needed |
| Galvant Industries GPIB-USB board | not yet supported | Hardware needed |
| Agilent 82357B USB/GPIB interface | not yet supported | Hardware needed |
Command sets
| Command set | Status | Comments |
|---|---|---|
| SCPI | planned | The standard is available here |
| IEEE-488.2 | not yet supported | Standard document needed |
Devices
| Device | Status | Interface | Comments |
|---|---|---|---|
| Agilent 7xxx | planned | USB-TMC | The standard is available here |
References
- IEEE-488 overview at wikipedia.
- SCPI overview at wikipedia.